Spirit System
https://www.spirit-system.com/phpBB3/

Unisense telemetry in 3.7.0 does not work correctly
https://www.spirit-system.com/phpBB3/viewtopic.php?f=24&t=6129
Page 1 of 1

Author:  STC... [ Mon 10. Jun 2024 18:11:21 ]
Post subject:  Unisense telemetry in 3.7.0 does not work correctly

Hardware:
Spirit 2 connected to Frsky Archer RS via F-Bus (+ and - connected to RUD and inverted S-Port to AIL)

Unisense connected to Spirit. (+ and - connected to free receiver channel and signal on left pin of SAT1)

Telemetry data is transmitted and ETHOS integration works.

but there are 2 problems:

ESC voltage: freezes after some time at 20.9V. (in several flights always at the same value)

Attachment:
volt2.png
volt2.png [ 123.38 KiB | Viewed 185 times ]


ESC consumption: The value rises too quickly at the beginning, then becomes slower and slower. (for comparison: the blue curve is the calculated consumption via current sensor)

Attachment:
mah.png
mah.png [ 114.93 KiB | Viewed 185 times ]


Attachments:
Logo-550-SE-FB-2024-06-09-14-31-27.csv [315.01 KiB]
Downloaded 10 times

Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/