Spirit System
https://www.spirit-system.com/phpBB3/

TBS Crossfire telemetry integrantion
https://www.spirit-system.com/phpBB3/viewtopic.php?f=24&t=3757
Page 8 of 9

Author:  jasc [ Thu 19. May 2022 10:59:21 ]
Post subject:  Re: TBS Crossfire telemetry integrantion

:mrgreen:
ZeXx86 wrote:
Upcoming firmware already has it working so CRSF protocol can be used. Unfortunately integration/telemetry with Spirit units will be enabled after this update. Fortunately there is no obstacle and next update will come within next few days. For flying it is already well tested.


:mrgreen: :mrgreen: :mrgreen:

Author:  Mike_Snoo [ Sun 05. Jun 2022 2:05:42 ]
Post subject:  Re: TBS Crossfire telemetry integrantion

Hey, in the release notes it says From now Spirit Pro, Spirit 2 and Spirit GT can use native CRSF protocol!

I have the regular Spirit unit. Will the regular Spirit unit work as well with crsf?

Author:  ZeXx86 [ Tue 07. Jun 2022 20:27:05 ]
Post subject:  Re: TBS Crossfire telemetry integrantion

Hello,

if regular Spirit mean the very first Spirit unit - Spirit 1, then there is high chance that no. But it is not excluded completely.

Author:  Mike_Snoo [ Fri 10. Jun 2022 18:26:30 ]
Post subject:  Re: TBS Crossfire telemetry integrantion

Yes, I guess I mean the spirit one. Well, cross fingers.

Author:  Mike_Snoo [ Fri 24. Jun 2022 19:47:18 ]
Post subject:  Re: TBS Crossfire telemetry integrantion

Any news on the Spirit 1 and Crossfire?

I would love to test it.

Author:  DjWang [ Wed 29. Jun 2022 4:13:03 ]
Post subject:  Re: TBS Crossfire telemetry integrantion

Has anyone been able to get telemetry using CRSF?

I switched my settings from sbus (via crossfire) to crossfire Ch1TX Ch2RX and was able to get all my regular radio functions working and diagnostics are all at -100 to +100.

I have wired CRSF Ch2RX to the "A" pin of SpiritGT and have Castle Edge160HV wired with 10Kohm resistor between signal and power to AUX1 pins with ground connected.

I believe I am getting ESC telemetry, when I spool the heli with no blades and move it around to get data logging I can see parameters in advanced data logging afterwards.

However I do not see the telemetry being sent to crossfire and then to opentx. I try "discover new sensors" many times with deleting them and trying again. I only get the crossfire telemetry and no telemetry from SpiritGT.

I have a ųspirit and tried the same to see if it would work that way with hobbywing telemetry but sadly CRSF is not supported on this unit

Sent from my SM-G991W using Tapatalk

Author:  minim [ Sat 02. Jul 2022 22:31:46 ]
Post subject:  Re: TBS Crossfire telemetry integrantion

I just tried to set it up to control for now but I didn't fly it yet as I was waiting for a update on the wiki to see if I set everything according to the manual. It still seems to be missing so I'll wait some more before I attempt anything.

http://manual.spirit-system.com/index.p ... sFire_CRSF

Author:  minim [ Wed 20. Jul 2022 17:15:02 ]
Post subject:  Re: TBS Crossfire telemetry integrantion

ZeXx86 wrote:
Hello,
*misquote


Will there be an update to this page? I want to test it but I'd like to read the docs before I fly off with it and do some stupid user error :P

http://manual.spirit-system.com/index.p ... sFire_CRSF

Edit: quoted the wrong post but the question is still the same :)

Author:  Mike_Snoo [ Tue 13. Sep 2022 10:37:04 ]
Post subject:  Re: TBS Crossfire telemetry integrantion

Is there any way spirit 1 could support crossfire?

Author:  MikeG4936 [ Sun 18. Sep 2022 15:15:33 ]
Post subject:  Re: TBS Crossfire telemetry integrantion

THANKS so much for bringing us Spirit CRSF support!

Any chance of integration of radio control via LUA script for RadioMaster TX16S?

Page 8 of 9 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/