|
It is currently Sun 12. May 2024 0:34:31
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 2 posts ] |
|
| Author |
Message |
|
Speedy
|
 Posted: Fri 29. Jul 2016 7:19:46 |
|
Joined: Wed 15. Apr 2015 11:02:30
Posts: 15
|
|
hi,
i use spirit with Jeti Mezon.
My Mezon is plugged inside the spirit and i use the mezon governor.
If my governor signal from transmitter send 70% because of wrong switch position.
The spirit send 0% til initalize process is finished to the mezon. The mezon initalize!!!!!!
After initialize of the spirit, spirit send the correct valu 70% the mezon.
Mezon is starting the governor and the Rotor start!!!
I think this is very DANGEROUS!
Is it possible that you check during intialization the motor singal from receiver?
Regards Sebastian
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Fri 29. Jul 2016 7:36:37 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12248
|
|
Hello,
when governor in the unit is enabled, it is checking throttle value.
When it is disabled, unit is sending value from the transmitter all the time, as soon as it will receive valid receiver data.
So it is not initializing with 0%. You can verify it with a servo in the AUX port.
_________________
Spirit System developer
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 45 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
