Spirit System
https://www.spirit-system.com/phpBB3/

Poor tail authority in stability scale
https://www.spirit-system.com/phpBB3/viewtopic.php?f=21&t=5554
Page 1 of 1

Author:  limabean1 [ Mon 06. Feb 2023 22:19:37 ]
Post subject:  Poor tail authority in stability scale

Hi All. I've been practising my 450l in stability normal but decided to change to scale. When I changed via the Bluetooth and a mobile the tail would not hold even when I pushed the gyro up to -90%. In normal I had it fine at -60% but I'm not sure what is happening in scale stability and why it won't hold solid. Can anyone assist maybe. Am I going up the wrong way should it be lower than -60.
Ta

Author:  Bgelok [ Tue 07. Feb 2023 3:44:16 ]
Post subject:  Re: Poor tail authority in stability scale

limabean1 wrote:
Hi All. I've been practising my 450l in stability normal but decided to change to scale. When I changed via the Bluetooth and a mobile the tail would not hold even when I pushed the gyro up to -90%. In normal I had it fine at -60% but I'm not sure what is happening in scale stability and why it won't hold solid. Can anyone assist maybe. Am I going up the wrong way should it be lower than -60.
Ta



From my understanding, Stabi Scale is Rate mode Only, not heading hold
In Normal Stabilization, heading hold is or tries to maintain on all control surfaces.

Maybe this helps

Author:  limabean1 [ Tue 07. Feb 2023 4:37:51 ]
Post subject:  Re: Poor tail authority in stability scale

So are you saying that I put my gyro back in to normal positive instead of negative as i had it for for stabi normal.

Author:  Rdlx3m [ Sun 11. Jun 2023 7:44:43 ]
Post subject:  Re: Poor tail authority in stability scale

limabean1 wrote:
Hi All. I've been practising my 450l in stability normal but decided to change to scale. When I changed via the Bluetooth and a mobile the tail would not hold even when I pushed the gyro up to -90%. In normal I had it fine at -60% but I'm not sure what is happening in scale stability and why it won't hold solid. Can anyone assist maybe. Am I going up the wrong way should it be lower than -60.
Ta



for scale you should have i at around + 55-70% headhold. NOT negative side of the gyro

next i wonder is how did you set up you scale switch? did you go to CHANNELS and assignet a swith to STABI SCALE ?
then you go to the STABI Menu and put it in SELECT BY CHANNEL

if your heli was flying good before you put it scale then this should not make any difference for tail.. only cyclic/stability

unless you changed someting

Author:  Danielrom [ Tue 13. Feb 2024 16:13:57 ]
Post subject:  Poor tail authority in stability scale.

Is it possible to enhance tail authority in stability scale helicopters by implementing unconventional design modifications or utilizing alternative control mechanisms?

Author:  limabean1 [ Sat 02. Mar 2024 2:27:11 ]
Post subject:  Re: Poor tail authority in stability scale

Still having issues with the gyro. The heli is in scale stability mode and the gyro has been run from 40 to 75 and it doesn't seem to make any difference to the waging that is present. Any thing I might be missing anyone.?

Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/