Spirit System
https://www.spirit-system.com/phpBB3/

Hobby wing telemetry cable
https://www.spirit-system.com/phpBB3/viewtopic.php?f=21&t=4635
Page 1 of 1

Author:  minim [ Sun 11. Apr 2021 23:15:43 ]
Post subject:  Hobby wing telemetry cable

Does anyone have the specs for the telemetry cable for a hobby wing v4 80a? My local shop just went out of stock and they are not ordering before they have a bigger order from spirit so I’m stuck without a cable..

Author:  cracked canopy [ Sun 11. Apr 2021 23:57:59 ]
Post subject:  Re: Hobby wing telemetry cable

It is just Signal and Ground connection.
Do NOT connect Power Lead (5V)
Observer the lead swap at the Sat connector end.

Author:  minim [ Mon 12. Apr 2021 23:37:31 ]
Post subject:  Re: Hobby wing telemetry cable

ok. The pictures are showing the red wire in both ends. Is it just not connected in the center piece with heatshrink on it? I notice the text also says to keep +5v out of it. So there is no level converter or anything inside that shrinkwrap?

Author:  jjuk [ Thu 29. Apr 2021 19:48:46 ]
Post subject:  Re: Hobby wing telemetry cable

It's not connected in the interface cable. Remove it.

Author:  minim [ Mon 19. Jul 2021 20:58:31 ]
Post subject:  Re: Hobby wing telemetry cable

cracked canopy wrote:
It is just Signal and Ground connection.
Do NOT connect Power Lead (5V)
Observer the lead swap at the Sat connector end.


I removed the red wire completly on my cable but I honestly can't see that the lead is swapped at SAT connector end. The picture in the wiki doesn't show them swapped? Could we make a basic drawing of this and upload it to the wiki so it's not confusing?

Author:  jjuk [ Tue 20. Jul 2021 1:02:27 ]
Post subject:  Re: Hobby wing telemetry cable

Spirit 2, looking from the top of the unit with the text the correct way, the connection to SAT1 is:

signal / ground / no connection.

(orange / brown / no connection)

Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/