|
It is currently Fri 11. Oct 2024 1:23:37
|
View unanswered posts | View active topics
|
Page 1 of 1
|
[ 2 posts ] |
|
Author |
Message |
senaka
|
Posted: Tue 23. Apr 2024 14:03:01 |
|
Joined: Wed 10. May 2023 9:36:53 Posts: 36 Location: The Netherlands
|
No really a Spirit specific question, but is there anyone who grounds the ECS/Servo negative wire to the frame? Some web sites advise doing it to prevent RX/flybarless controller reboots(or worse damage) and some are against it and advice to use silicone lubrication on the tail belt.
|
|
Top |
|
|
ZeXx86
|
Posted: Tue 23. Apr 2024 19:50:41 |
|
|
Site Admin |
Joined: Mon 29. Apr 2013 16:06:44 Posts: 12398
|
This depends mainly on helicopter. Some older helicopters required a proper grounding. Some more recent does not need it at all, because it is built in in the frame or at least belt is made from material that does not produce so big static discharges. Generally it is not needed, but in a rare cases even grounded model might cause problems. For example if tail boom has a lot of powder from the belt inside already.
_________________ Spirit System developer
|
|
Top |
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
|
Who is online |
|
Users browsing this forum: No registered users and 1 guest |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|