|
It is currently Thu 16. May 2024 15:15:17
|
View unanswered posts | View active topics
| Author |
Message |
|
ZeXx86
|
 Posted: Mon 20. Apr 2015 13:40:11 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12251
|
|
Ah, then I recommend to increase Gyro Gain.
What is your RPM? If it is too low, then rudder is mechanically not able to hold the rudder.
Also it is important to configure Governor or throttle curve correctly so the RPM are holding well too.
_________________
Spirit System developer
|
|
| Top |
|
 |
|
pabloK
|
Posted: Mon 20. Apr 2015 21:49:09 |
|
Joined: Tue 17. Feb 2015 14:42:04
Posts: 56
|
|
I configured governor on the castle edge HV80 at
idle up 1: 2388
idle up 2: 2459
I tried the funnels on idle up 2
do you recommend another setting? more RPM or maybe V or flat curve ?
thanks
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Mon 20. Apr 2015 21:56:53 |
|
|
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12251
|
|
RPM is OK.
First from all you should try to increase Gyro Gain as high as possible without tail oscillations.
Then if the rudder will still not hold perfectly increasing Piro Consistency is needed. It shouldn't be higher than 190.
_________________
Spirit System developer
|
|
| Top |
|
|
|
pabloK
|
Posted: Mon 20. Apr 2015 22:34:41 |
|
Joined: Tue 17. Feb 2015 14:42:04
Posts: 56
|
|
great, I will try
what do you think of the other parameters in order to get a smooth and precise feeling flying style?
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Tue 21. Apr 2015 9:28:19 |
|
|
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12251
|
|
I recommend to set 25-30% expos in your transmitter, configure Flight Style to 6-8, increase Elevator Filter to 2-3 and set frequency for the cyclic servos to 200Hz.
_________________
Spirit System developer
|
|
| Top |
|
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 39 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
