Spirit System

[SOLVED] Radio and Servo reversing - How-To
Page 1 of 1

Author:  Bladecrasher [ Thu 22. Sep 2022 2:43:59 ]
Post subject:  [SOLVED] Radio and Servo reversing - How-To

Every time I need to get my DX9 setup with a new model - I have to F..K around with the reversing on the TX and Spirit before the swash is moving correctly.

This is such a BS problem, there must be a step-by-step "how-to" explanation of getting this resolved. Does anyone have a link to something helpful or an explanation of the process of elimination.

The manual seems useless for this.

Thank you,

Author:  ZeXx86 [ Thu 22. Sep 2022 8:56:36 ]
Post subject:  Re: Radio and Servo reversing - How-To


there are only two steps that you have to do in regards to reversing.

1. Reverse radio channels according Diagnostic tab/Setup wizard and from then never touch these reverses.
2. Reverse servos in the Servos tab/Setup wizard to achieve correct movements. It is enough to move with pitch stick up and down and reverse all servos that are moving in a wrong direction.

Then you are done.

If you are using a digital channel transmission protocol such as Spektrum DSM2/X or SRXL2 (no PWM or PPM) then point 1 will be correct out of the box. So then no reversing in your radio is needed at all.

In other words it is enough to proceed according Setup Wizard.

Author:  Bladecrasher [ Fri 23. Sep 2022 13:30:15 ]
Post subject:  Re: Radio and Servo reversing - How-To

Thank you. Re-doing the Wizard made this easy.

Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group