| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Built-in telemetry variables https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=5328 |
Page 1 of 1 |
| Author: | Scott H [ Sun 07. Aug 2022 1:59:34 ] |
| Post subject: | Built-in telemetry variables |
I have Spirit, Spirit Pro and Spirit GTR (haven't used the GTR yet). In the Jeti (DS-12), under Timers/sensors and then sensors/logging; I see S Vibes and S RPM - Am I correct that they are telemetry values from Spirit? I want also Battery Voltage as a telemetry variable - will the GTR have that? is there any other way beside adding an MUI or unisense, or related add-on? Thanks |
|
| Author: | Habásek [ Sun 07. Aug 2022 9:28:59 ] |
| Post subject: | Re: Built-in telemetry variables |
Yes, S xx values are telemetry values from Spirit units. For voltage values and similar, you have to use a MUI sensor or a speed controller that has telemetry (and you either send it to the Spirit unit or to the Jeti receiver to the EXT port), the instructions are here: http://manual.spirit-system.com/index.php?title=ESC_telemetry |
|
| Author: | Scott H [ Sun 07. Aug 2022 11:26:16 ] |
| Post subject: | Re: Built-in telemetry variables |
Thank you for your reply. I should have mentioned, this is a gasser heli (no esc). Still, the approach is the same. I need a MUI or equivalent. Regards, |
|
| Author: | Habásek [ Sun 07. Aug 2022 12:25:08 ] |
| Post subject: | Re: Built-in telemetry variables |
For glow or gasoline engines, either the voltage indicator of the receiver in the radio is enough to monitor the on-board battery, or to monitor multiple batteries, e.g.: http://support.jetimodel.cz/en/katalog/Duplex-2-4-EX/Measure-Sensors-EX/@produkt/MU3-EX/ RPM sensor: http://support.jetimodel.cz/en/katalog/Duplex-2-4-EX/Measure-Sensors-EX/@produkt/MRPM-HALL-EX/ http://support.jetimodel.cz/en/katalog/Duplex-2-4-EX/Measure-Sensors-EX/@produkt/MRPM-EX/ other: http://support.jetimodel.cz/en/katalog/Duplex-2-4-EX/Measure-Sensors-EX/@produkt/MFlow2-G800-EX/ |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|