Spirit System
https://www.spirit-system.com/phpBB3/

Where is the laser and do I need to keep free of it?
https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=5326		 Page 1 of 1
Author:  madman [ Sat 06. Aug 2022 9:44:42 ]
Post subject:  Where is the laser and do I need to keep free of it?
Hi there, I have tried to find info about the laser on Geolink v2 - obviously it is below the device, where the golden pattern is in the little box on one side, right? Is it's direction 90° from the devices box to the ground?

If I create my own mount with my 3D printer, do I have to make sure, that the way to the ground is free - so nothing is covering this part of the device? How do you do that with the big tail boom of a Kraken 580 - now way can this laser have visivble sight to ground, if mounted on top.

I'm just collecting ideas to solve this - if the laser is really needed - is it?

A lot of questions for which I haven't found any answers yet.

Thanks for your hints,
Oliver
Author:  Dr.Fleming [ Tue 09. Aug 2022 18:38:07 ]
Post subject:  Re: Where is the laser and do I need to keep free of it?
It not must be all the time on the boom! :?:

madman wrote:
Hi there, I have tried to find info about the laser on Geolink v2 - obviously it is below the device, where the golden pattern is in the little box on one side, right? Is it's direction 90° from the devices box to the ground?

If I create my own mount with my 3D printer, do I have to make sure, that the way to the ground is free - so nothing is covering this part of the device? How do you do that with the big tail boom of a Kraken 580 - now way can this laser have visivble sight to ground, if mounted on top.

I'm just collecting ideas to solve this - if the laser is really needed - is it?

A lot of questions for which I haven't found any answers yet.

Thanks for your hints,
Oliver
Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/