Spirit System https://www.spirit-system.com/phpBB3/ |
|
Where is the laser and do I need to keep free of it? https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=5326 |
Page 1 of 1 |
Author: | madman [ Sat 06. Aug 2022 9:44:42 ] |
Post subject: | Where is the laser and do I need to keep free of it? |
Hi there, I have tried to find info about the laser on Geolink v2 - obviously it is below the device, where the golden pattern is in the little box on one side, right? Is it's direction 90° from the devices box to the ground? If I create my own mount with my 3D printer, do I have to make sure, that the way to the ground is free - so nothing is covering this part of the device? How do you do that with the big tail boom of a Kraken 580 - now way can this laser have visivble sight to ground, if mounted on top. I'm just collecting ideas to solve this - if the laser is really needed - is it? A lot of questions for which I haven't found any answers yet. Thanks for your hints, Oliver |
Author: | Dr.Fleming [ Tue 09. Aug 2022 18:38:07 ] |
Post subject: | Re: Where is the laser and do I need to keep free of it? |
It not must be all the time on the boom! madman wrote: Hi there, I have tried to find info about the laser on Geolink v2 - obviously it is below the device, where the golden pattern is in the little box on one side, right? Is it's direction 90° from the devices box to the ground?
If I create my own mount with my 3D printer, do I have to make sure, that the way to the ground is free - so nothing is covering this part of the device? How do you do that with the big tail boom of a Kraken 580 - now way can this laser have visivble sight to ground, if mounted on top. I'm just collecting ideas to solve this - if the laser is really needed - is it? A lot of questions for which I haven't found any answers yet. Thanks for your hints, Oliver |
Page 1 of 1 | All times are UTC + 1 hour |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |