It is currently Fri 29. Mar 2024 10:02:55

All times are UTC + 1 hour





Post new topic Reply to topic  [ 27 posts ]  Go to page Previous  1, 2, 3  Next
  Print view Previous topic | Next topic 
Author Message
PostPosted: Fri 08. Jul 2022 17:57:03 
Offline

Joined: Wed 04. Jul 2018 18:03:55
Posts: 175
"Second, if you clued the connector in full on the spirit, and therefore the Baro not get air inside,
than you are in trouble."

You still have the LED hole... ;)


Top
 Profile  
 
PostPosted: Fri 08. Jul 2022 18:48:15 
Offline

Joined: Thu 05. Oct 2017 20:06:35
Posts: 305
It's a geolink module. The led doesn't have a hole.

I've swapped the 2 modules I have over and will test later on a heli that holds well and the 500x that doesn't.

I'll also try without the geolink case lid fitted incase it is too sealed to work.


Top
 Profile  
 
PostPosted: Sun 10. Jul 2022 12:19:02 
Offline

Joined: Thu 05. Oct 2017 20:06:35
Posts: 305
Swapping the geolink modules didn't make any difference so I can only assume the geolink is working correctly and the problem is software related (or my spirit2 is faulty).
The heli flies fine manually.

My setting file is attached to an earlier post. (post #5).

Can someone at Spirit please propose a solution. Thanks.


Top
 Profile  
 
PostPosted: Sat 16. Jul 2022 11:33:35 
Offline

Joined: Thu 05. Oct 2017 20:06:35
Posts: 305
@ZeXx86 Any thoughts on what is wrong here?


Top
 Profile  
 
PostPosted: Sun 17. Jul 2022 23:05:04 
Offline

Joined: Thu 05. Oct 2017 20:06:35
Posts: 305
Here's a video of the problem. Clearly, that's not holding the position.

https://clipchamp.com/watch/8nerYkbyfvb


Top
 Profile  
 
PostPosted: Mon 18. Jul 2022 7:38:30 
Offline
Site Admin

Joined: Mon 29. Apr 2013 16:06:44
Posts: 12213
Hello,

the problem could happen if servo neutral point is not mechanically in the center.

You can check if it is good by enabling Servos / Subtrim (tuning) menu. Then all 4 servos should move exactly to the middle of their travel range. Servo arm should be at 90° - as precise as possible.
At the same time there should be 0° between main blades.

If you are unsure then you can take a photo of the swashplate + servos when menu is enabled and I will check it.

_________________
Spirit System developer


Top
 Profile  
 
PostPosted: Wed 20. Jul 2022 0:30:20 
Offline

Joined: Thu 05. Oct 2017 20:06:35
Posts: 305
I have checked this. When subtrim check box is enabled, the 3 cyclic servo arms are at 90 degrees, and both blades are at 0 degrees of pitch.

I am using servo travel correction to ensure that the swash is level throughout the full cyclic range. It has been mentioned in this thread that this may be an issue. I'm assuming that the auto-flying modes (rth, pos and alt hold, stabi, rescue) all control the servos AFTER any travel correction has been applied and taken into consideration in the calculations, correct?


Top
 Profile  
 
PostPosted: Wed 20. Jul 2022 10:58:43 
Offline

Joined: Sun 18. Apr 2021 16:54:57
Posts: 211
Looks to much gain on Vertical gain !

jjuk wrote:
Here's a video of the problem. Clearly, that's not holding the position.

https://clipchamp.com/watch/8nerYkbyfvb


Top
 Profile  
 
PostPosted: Wed 20. Jul 2022 11:36:19 
Offline

Joined: Thu 05. Oct 2017 20:06:35
Posts: 305
Its set to 20%. I can't change it any lower.


Top
 Profile  
 
PostPosted: Wed 20. Jul 2022 18:34:51 
Offline

Joined: Sun 18. Apr 2021 16:54:57
Posts: 211
Go trough the "SETUP WIZARD" and check your setup,
and in case correction it, there is no other.

jjuk wrote:
Its set to 20%. I can't change it any lower.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 27 posts ]  Go to page Previous  1, 2, 3  Next

All times are UTC + 1 hour


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  



Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
skymiles_red v1.0.1 designed by Team -Programming forum-سيارات للبيع .