Spirit System https://www.spirit-system.com/phpBB3/ |
|
Vers. 3.4.0 Question: Rescue and Stabilization one Channel https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=5224 |
Page 1 of 1 |
Author: | pinkisoft [ Sat 28. May 2022 14:00:27 ] |
Post subject: | Vers. 3.4.0 Question: Rescue and Stabilization one Channel |
Hello, I have installed the current 3.4.0 version and am still looking for the setting that I can use a switch and, above all, a channel to control the rescue function and stabilization. The way I see it, I always have to keep at least 2 channels for it. Wish: on 3-way switch with a rocker switch position: - Switch position 1 (down): stabilization and rescue off - Switch position 2 (middle): stabilization - Switch position 3 (rocker switch - up): rescue function Is it controlled via one channel or do at least 2 channels have to be used for it? The way I understand the new "assign to channel" function is that I have to use one channel for each type of stabilization mode. Unfortunately I don't have that many channels. Thank you for your answer. Norbert |
Author: | ZeXx86 [ Sat 28. May 2022 14:34:01 ] |
Post subject: | Re: Vers. 3.4.0 Question: Rescue and Stabilization one Chann |
Hello, you can set 2-3 functions on one channel for years already. It is enough to use Bank Switching, set different function to each bank and set there a Negative Gyro gain in the Sensor Tab - Gyro Gain channel must be unassigned in the Channels window. Then you can change between these functions immediately just by one channel. |
Page 1 of 1 | All times are UTC + 1 hour |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |