Thanks for the clarification and my error.
My situation has gone from bad to worse.
I started over, reset servo directions in my radio, reconnected servo wires as the wiring guide illustrates, went through the wizard, got the servos moving in the correct direction per the diagnose tab, next, to servo reversing in wizard, servos just don't behave properly, no matter what I tried.
Disgusted, I tried to downgrade to my old version to see if it was something in 3.3.3. I uninstalled 3.3.3 and removed the driver, reinstalled the 3.1.0, and driver, restarted the computer. connected USB to sys port powered up heli, started software, Spirit software described the mismatch and opened - went to the update tab, chose the 3.1.0 firmware and flashed. Flashed never finished and now the Spirit has a slow flashing red light.
Attempted to follow:
http://manual.spirit-system.com/index.p ... ing_Failed and I could not get the Spirit software to open or get beyond the logo of searching for units.
I connected a second Spirit to the computer and that opened fine, so to me any, seems like the Spirit software and driver are working.
Now I'm stuck ! (and I feel like an idiot)