It is currently Thu 28. Mar 2024 14:50:22

All times are UTC + 1 hour





Post new topic Reply to topic  [ 12 posts ]  Go to page Previous  1, 2
  Print view Previous topic | Next topic 
Author Message
PostPosted: Mon 29. Nov 2021 17:51:35 
Offline

Joined: Wed 21. Dec 2016 15:13:38
Posts: 480
Location: Germany
Hello Tomas !
Thanks a lot for your answer ! I am very happy to say it works flawlessly ! :D
I had the last firmware, but I probably made a mistake myself - right after reading your answer I rushed into the basement and tried it out and what can I say, it worked without any problems! The whole point for me was to hold the two sticks in the respective corners and roll the roller to the right, because I didn't do that before, I just held the sticks in the corners and waited for a window to open ...

Once again, thank you very much for your help and great support!

Many greetings
Matthias


Top
 Profile  
 
PostPosted: Fri 20. Jan 2023 2:32:16 
Offline

Joined: Wed 07. Sep 2022 4:25:35
Posts: 2
Quote !!
Thanks a lot for your answer ! I am very happy to say it works flawlessly ! :D
I had the last firmware, but I probably made a mistake myself - right after reading your answer I rushed into the basement and tried it out and what can I say, it worked without any problems! The whole point for me was to hold the two sticks in the respective corners and roll the roller to the right, because I didn't do that before, I just held the sticks in the corners and waited for a window to open ...

So happy I found this thread. I have read and reread the integration directions so many times. Did every update on everything I had in the system. I was doing exactly what you where. Hold the sticks both in for 2 plus seconds and nothing. Like you said no blank screen either and no integration. Did not see or understand anything about the roller will holding the sticks in, but importantly it works !! YES finally

4.1 Entering the menu
At this point the integration menu is closed so you can't accidently configure any parameter. To open the menu, move the Rudder stick to the right and Aileron stick to the left and hold for over 2 seconds. Once the menu is opened, you will see <READY> message. Now you can release the sticks and you are ready to set all the parameters.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 12 posts ]  Go to page Previous  1, 2

All times are UTC + 1 hour


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  



Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
skymiles_red v1.0.1 designed by Team -Programming forum-سيارات للبيع .