It is currently Thu 28. Mar 2024 13:32:46

All times are UTC + 1 hour





Post new topic Reply to topic  [ 33 posts ]  Go to page 1, 2, 3, 4  Next
  Print view Previous topic | Next topic 
Author Message
 Post subject: GT initializing
PostPosted: Sat 10. Jul 2021 19:38:47 
Offline

Joined: Wed 04. Jul 2018 18:03:55
Posts: 175
Hello Tomas
Slight problem with my GT. The 1st time i connect the receiver battery some times the GT just puts the blue led on with no flash and does not initalize and nothing works.
If i disconnect the battery and plug in right away the led flashes and it all works ok....If i carry on conecting and disconecting battery it initializes evey time, but if i leave it for a while
it goes back to not starting. If it is starting ok all works well and flies good. Just a bit concerned....Jeti DS12 with Rex3 and Spirit GT...
Regards Adrian


Top
 Profile  
 
 Post subject: Re: GT initializing
PostPosted: Sat 10. Jul 2021 20:20:08 
Offline

Joined: Fri 09. Jul 2021 8:12:20
Posts: 10
I have observed exactly the same.
Ds14, Rex3

Sometimes it takes 2 Power up cycles to init GT.

If it is up... everything works fine

BR
Philip


Top
 Profile  
 
 Post subject: Re: GT initializing
PostPosted: Sat 10. Jul 2021 20:38:56 
Offline
User avatar

Joined: Tue 10. Mar 2020 14:36:22
Posts: 352
Hi,
how is the setup of the Rex3?

_________________
cheers
Michael


Top
 Profile  
 
 Post subject: Re: GT initializing
PostPosted: Sat 10. Jul 2021 21:37:01 
Offline

Joined: Tue 29. Jun 2021 17:39:22
Posts: 8
Hello,

i have the same problem with my futaba t14sg via s-bus.

Heri


Top
 Profile  
 
 Post subject: Re: GT initializing
PostPosted: Sat 10. Jul 2021 22:10:52 
Offline

Joined: Wed 04. Jul 2018 18:03:55
Posts: 175
HeliMLM wrote:
Hi,
how is the setup of the Rex3?

Output Period = 17ms
ppm/udi mode = direct
fail safe delay = 1.5s
2/E1 = exbus
Not sure if you mean any other details....
Just to add i am using life battery for receiver/spirit...


Top
 Profile  
 
 Post subject: Re: GT initializing
PostPosted: Sun 11. Jul 2021 9:55:20 
Offline
User avatar

Joined: Tue 10. Mar 2020 14:36:22
Posts: 352
i've not seen this happen to my GT so far. i am using 10ms and failsafe off (= to be done by Spirit unit) on all my Spirit units. i powered it either by 4xEneloop or 2s LiPo on bench and later directly out of YGE Bec (7.7V).

did you check the Spirit log when this happened? there should be some entry telling "why" it is not initializing... (and maybe: is Jeti telemetry already working correctly at this time? receiver correctly bound and responding? Spirit telemetry items?)

_________________
cheers
Michael


Top
 Profile  
 
 Post subject: Re: GT initializing
PostPosted: Sun 11. Jul 2021 10:25:00 
Offline

Joined: Wed 04. Jul 2018 18:03:55
Posts: 175
HeliMLM wrote:
i've not seen this happen to my GT so far. i am using 10ms and failsafe off (= to be done by Spirit unit) on all my Spirit units. i powered it either by 4xEneloop or 2s LiPo on bench and later directly out of YGE Bec (7.7V).

did you check the Spirit log when this happened? there should be some entry telling "why" it is not initializing... (and maybe: is Jeti telemetry already working correctly at this time? receiver correctly bound and responding? Spirit telemetry items?)


I have now changed rx to 10ms, telementry from jeti rx all working but not from GT, Will wait awhile and retest, when starts up ok log reports all good...


Last edited by 10x on Sun 11. Jul 2021 22:06:15, edited 1 time in total.

Top
 Profile  
 
 Post subject: Re: GT initializing
PostPosted: Sun 11. Jul 2021 14:53:39 
Offline
User avatar

Joined: Mon 06. Aug 2018 2:10:40
Posts: 29
I have the same issue as well!
Futaba 18SZ, S-Bus with R7008SB receiver, running off a 2S lipo.


Top
 Profile  
 
 Post subject: Re: GT initializing
PostPosted: Mon 12. Jul 2021 7:44:27 
Offline
Site Admin

Joined: Mon 29. Apr 2013 16:06:44
Posts: 12210
Can you let me know if you have RealTime logging enabled? Also you can share your settings file please so we can find the problem.

_________________
Spirit System developer


Top
 Profile  
 
 Post subject: Re: GT initializing
PostPosted: Mon 12. Jul 2021 8:12:28 
Offline

Joined: Wed 04. Jul 2018 18:03:55
Posts: 175
Yes for real time logging and file attached...


Attachments:
Rufus E755.4ds [255 Bytes]
Downloaded 22 times
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 33 posts ]  Go to page 1, 2, 3, 4  Next

All times are UTC + 1 hour


Who is online

Users browsing this forum: Bing [Bot] and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  



Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
skymiles_red v1.0.1 designed by Team -Programming forum-سيارات للبيع .