It is currently Thu 28. Mar 2024 22:30:14

All times are UTC + 1 hour





Post new topic Reply to topic  [ 1 post ] 
  Print view Previous topic | Next topic 
Author Message
 Post subject: Spirit Governor Setup
PostPosted: Mon 15. Mar 2021 2:51:58 
Offline

Joined: Sun 21. Jul 2019 22:35:24
Posts: 11
I have a question the Spirit 2 governor setup. I hooked up a fresh lipo and did some test head speed runs without blades on a Goblin 380 Buddy helicopter. I set the max head speed in Spirit at 3700 and my throttle curve for Normal, Stunt 1 and Stunt 2 as 70%, 75% and 80%, respectively.

When I ran my head speed test, the Spirt app indicated a Requested RPM of Normal at 2579, Stunt 1 at 2764, and Stunt 2 at 2949. However, the max current speed it would get to was about 2,170 or so and that Current RPM did not change between Normal, Stunt 1 and Stunt 2. The Request RPMs would change when I would switch between them but not the actual RPMs. I’m assuming this is because the current RPMs could not reach the minimum requested speed I had set.

Any ideas on why the current RPMs will not even reach 2200 rpms? I was using a fresh fully charged 6s 2200 lipo. I would appreciate any suggestions.

Thanks in advance!
Keith


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC + 1 hour


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron



Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
skymiles_red v1.0.1 designed by Team -Programming forum-سيارات للبيع .