Spirit System https://www.spirit-system.com/phpBB3/ |
|
Spirit 2 with Futaba FASStest https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=4459 |
Page 1 of 1 |
Author: | jszewczyk [ Wed 30. Dec 2020 2:15:33 ] |
Post subject: | Spirit 2 with Futaba FASStest |
Hi, I want to connect telementry for Futaba 14SG (Futaba R7008SB) and Hobbywing Platinum 60A V4 ESC It would work with Spirit 2 with Frsky Cable? http://manual.spirit-system.com/index.p ... _Telemetry Telemetry from Platinum 60A V4 ESC I make like this, with Telem UNI cable? http://manual.spirit-system.com/index.p ... _Telemetry Thanks for help. I'm not sure, because I found only information about Spirit 1 Best, Jacek |
Author: | ZeXx86 [ Wed 30. Dec 2020 8:22:38 ] |
Post subject: | Re: Spirit 2 with Futaba FASStest |
Hi, yes, you are right. You will need both cables to make it work together. |
Author: | ZeXx86 [ Thu 01. Apr 2021 20:48:50 ] |
Post subject: | Re: Spirit 2 with Futaba FASStest |
Hi, what about other telemetry values? For example Battery Voltage? Is your ESC updated to the latest firmware (but not for VBar)? |
Author: | jszewczyk [ Thu 01. Apr 2021 21:39:32 ] | ||||
Post subject: | Re: Spirit 2 with Futaba FASStest | ||||
All telementry read from spirit 2 in Futaba works fine, RPM too. Problem is only with value in governor RPM metter in governor setting, because of zero. ESC is uptodate. Please take a look in attachments.
|
Author: | ZeXx86 [ Thu 01. Apr 2021 21:48:19 ] |
Post subject: | Re: Spirit 2 with Futaba FASStest |
This is all correct. You can't use RPM value from telemetry for governor. Spirit app is showing data from sensor, but there is no RPM sensor connected. |
Author: | jszewczyk [ Thu 01. Apr 2021 21:50:40 ] | ||
Post subject: | Re: Spirit 2 with Futaba FASStest | ||
Aaaa. How can I connect rpm sensor, becouse of this port is used for frsky interface for futaba
|
Author: | ZeXx86 [ Thu 01. Apr 2021 21:53:55 ] |
Post subject: | Re: Spirit 2 with Futaba FASStest |
You can add wire from the ESC in the middle position. This is unused. You can use connector from the FrSky integration cable. Or change servo connector to a single pin plastic. Then you can connect and disconnect both separately. |
Author: | jszewczyk [ Thu 01. Apr 2021 21:59:18 ] |
Post subject: | Re: Spirit 2 with Futaba FASStest |
I added in the middle position. Thanks! Works great, my Master |
Page 1 of 1 | All times are UTC + 1 hour |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |