| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Connection MicroSpirit , YGE FLV35 , Graupner HOTT Receiver https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3935 |
Page 1 of 1 |
| Author: | scvflyer [ Mon 04. May 2020 6:50:22 ] |
| Post subject: | Connection MicroSpirit , YGE FLV35 , Graupner HOTT Receiver |
Hello service team, would like to use Micro Spirit's governour and telemetry from HOTT (RX 12L). And as ESC - YGE 35LV. Therefore I have to connect SUMD (CH6) to RUD; Telemetry(CH5) to SYS. That's fine. I guess it is correct to use red wire from YGE (after YGE TexY - and of course coming from blue connector) and connect it to AUX1 from Micro Spirit for RPM signal. But which pin is it at Spirit? And how get I ESC's telemetry data into micro spirit in that combination ? Or is it easy as it looks like - just plug in blue connector from YGE (of course using YGE TexY in between) to AUX1 ? ESC has been set to use ext. governour thanks and kind regards Siggi |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|