Oh, I dont know what Anti-Torque is
Can you explain in other words please?
Is it Aileron, Elevator, Rudder?
| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Anti torque does not hold in reverse https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3493 |
Page 1 of 1 |
| Author: | passe partout [ Mon 29. Jul 2019 18:06:05 ] |
| Post subject: | Anti torque does not hold in reverse |
Hello, during fast walks back with my 450 trex, the anti torque does not hold the axis he picks up suddenly, what setting I have to do. The gain seems good to me before it is stable and do not oscillations. I speak in flight by not moving forward Thank you |
|
| Author: | ZeXx86 [ Tue 30. Jul 2019 11:08:47 ] |
| Post subject: | Re: Anti torque does not hold in reverse |
Hello, I am not sure if I understand correctly, but it is possible that you are talking about Fast forward flight and sudden elevator movement (usually up). This is caused due to small Cyclic Ring and/or too high Collective Pitch. Please increase Aileron/Elevator Range in the Limits tab or decrease Collective Pitch range. Then all should be fine. |
|
| Author: | passe partout [ Tue 30. Jul 2019 11:56:19 ] |
| Post subject: | Re: Anti torque does not hold in reverse |
Hi Thomas, in fast reverse, the anti couple picks up and the helicopter turns quickly. I use a translator it's not easy; O)) Si qqun veut traduire: Lors des marches arrières rapides l’anti-couple décroche violemment et l'hélicoptère fait un demi tour rapide pour se remettre dans l'axe de vol. Merci |
|
| Author: | passe partout [ Wed 31. Jul 2019 10:37:43 ] |
| Post subject: | Re: Anti torque does not hold in reverse |
The anti-torque does not hold in reverse it violently unhooks |
|
| Author: | ZeXx86 [ Wed 31. Jul 2019 12:37:30 ] |
| Post subject: | Re: Anti torque does not hold in reverse |
Oh, I dont know what Anti-Torque is Can you explain in other words please? Is it Aileron, Elevator, Rudder? |
|
| Author: | passe partout [ Wed 31. Jul 2019 12:43:15 ] |
| Post subject: | Re: Anti torque does not hold in reverse |
rudder |
|
| Author: | ZeXx86 [ Wed 31. Jul 2019 12:49:41 ] |
| Post subject: | Re: Anti torque does not hold in reverse |
Now I understand. Please check Limits/Rudder End-points. It must be configured in the full extent, especially closer to the boom. Next important thing is to set RPM high enough, because with a small headspeed rudder efficiency can be too low. |
|
| Author: | passe partout [ Wed 31. Jul 2019 12:54:33 ] |
| Post subject: | Re: Anti torque does not hold in reverse |
ZeXx86 wrote: Now I understand.
Please check Limits/Rudder End-points. It must be configured in the full extent, especially closer to the boom. MAXI Next important thing is to set RPM high enough, because with a small headspeed rudder efficiency can be too low. MAXI |
|
| Author: | passe partout [ Thu 01. Aug 2019 19:49:17 ] |
| Post subject: | Re: Anti torque does not hold in reverse |
I think I have a better flight with the setting "Pirouette consistency" increased from 160 to 177. Cdlt |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|