Spirit System

FrSky XSR and uSpirit - Connection
Page 2 of 2

Author:  EndoDusk [ Sat 28. Mar 2020 20:16:02 ]
Post subject:  Re: FrSky XSR and uSpirit - 3.3v OK to plug into SYS port?

I have a question about whether it's OK to put 3.3v into the SYS port? I read on the Spirit System's Manual online that you should NEVER put voltage into the SYS or AIL/ELE/PIT port either. But when I hook up the FrSky Integration Cable to my XSR and add voltage to it from AUX1 on Spirit Pro, it shows 3.3v output on the red side of the cable. Is this OK?

Author:  ZeXx86 [ Sun 29. Mar 2020 20:17:15 ]
Post subject:  Re: FrSky XSR and uSpirit - Connection

Usage FrSky integration cable is - of course, correct.
If you will use it as described in the manual, there will be no issue.

Connecting anything else could result in a bad outcome.

3.3V is signal voltage.

Page 2 of 2 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group