| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Scale setup https://www.spirit-system.com/phpBB3/viewtopic.php?f=17&t=892 |
Page 2 of 2 |
| Author: | mkgy [ Tue 27. Oct 2015 18:11:20 ] | ||
| Post subject: | Re: Scale setup | ||
After much testing, there is still problem. 1. Sometimes stop for a moment the even at full rudder. Rudder servo: Align DS650 2. While pirouette sometimes the heli self aileron direction overthrown. Governance must be strong opposition. I don't know what setup. Thank you in advance for your help.
|
|||
| Author: | ZeXx86 [ Wed 28. Oct 2015 10:16:05 ] |
| Post subject: | Re: Scale setup |
Are you sure that the Pirouette Optimization is correct? I understand that is is very hard to check it on the ground. For example when you change rudder servo or rudder mechanics, it can be result for the opposite settings. |
|
| Author: | mkgy [ Wed 28. Oct 2015 10:50:55 ] |
| Post subject: | Re: Scale setup |
The Pirouette Optimization setup correct. Do not every pirouette occur. |
|
| Author: | ZeXx86 [ Wed 28. Oct 2015 14:02:52 ] |
| Post subject: | Re: Scale setup |
Are you sure that CG is good? This can cause this issue as well. |
|
| Author: | mkgy [ Wed 28. Oct 2015 14:03:57 ] |
| Post subject: | Re: Scale setup |
Then tested the rudder servo ball farther. |
|
| Author: | mkgy [ Wed 28. Oct 2015 14:07:00 ] |
| Post subject: | Re: Scale setup |
CG correct. Main rotor shaft vertical. |
|
| Author: | mkgy [ Wed 28. Oct 2015 14:08:14 ] |
| Post subject: | Re: Scale setup |
The problem may not be that counterclockwise rotation of the rotor? |
|
| Author: | ZeXx86 [ Wed 28. Oct 2015 19:38:28 ] |
| Post subject: | Re: Scale setup |
This shouldn't be a problem. Does it happen always only to one side only? Where is your collective pitch when you are hovering? (approx. position) |
|
| Author: | mkgy [ Wed 28. Oct 2015 20:52:21 ] |
| Post subject: | Re: Scale setup |
It occurs in both directions. Hovering approx 4-5 degree. |
|
| Author: | ZeXx86 [ Fri 30. Oct 2015 8:22:57 ] |
| Post subject: | Re: Scale setup |
It really looks like there is wrong pirouette optimization direction. This behavior exactly correspond with the state when it is configured in opposite direction. How did you tested that it is configured properly? Maybe after initial configuration you have changed Sensor compensation direction for Rudder - this will lead in the problem that it is reversed. |
|
| Page 2 of 2 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|
