|
It is currently Sat 27. Apr 2024 6:58:48
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
flo
|
 Posted: Mon 18. Mar 2024 20:51:41 |
|
Joined: Tue 20. Feb 2024 23:20:33
Posts: 7
|
|
Hi
I just played arround with the RPM telemetrie.
Is it normal that i sometimes see the RPM signal as 0 ?
See attached Scrreenshot.
At the moment i use the govenor of the ESC (Hobbywing 200A Opto)
IT´s connected via telemetiry and RPM cable (with the HOBBYWING-Signal-Coupler-Modul)
Not sure the Logs shows the telmetrie DATA or the RPM Signal Data.
Hope somebody has an idea?
best regards
Florian
| Attachments: |
rpm.PNG [ 124 KiB | Viewed 116 times ]
|
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Tue 19. Mar 2024 16:04:25 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12235
|
|
Helo,
log is showing RPM cable signal.
Can you disconnect the RPM cable and check again the log?
This problem could happen if signal is very weak or there is interference. It must be routed carefully, not near a source of interference.
_________________
Spirit System developer
|
|
| Top |
|
|
|
flo
|
Posted: Fri 29. Mar 2024 14:00:44 |
|
Joined: Tue 20. Feb 2024 23:20:33
Posts: 7
|
|
OK - it works fine with RPM disconnected and just the telemetrie data.
I suppose it must be the RPM Copler Mudle from the hobbywing esc
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 4 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
