Spirit System :: View topic - [SOLVED] HOTT MX-16

Spirit System https://www.spirit-system.com/phpBB3/

[SOLVED] HOTT MX-16 https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=5894	Page 1 of 1

Author:	compuger [ Tue 05. Dec 2023 15:17:50 ]
Post subject:	[SOLVED] HOTT MX-16
Hello, I use SPIRIT GT with my HOTT MX-16 remote control. My question would be, does HOTT INTEGRATION also work with MX-16??? I can't find this option "option SENSOR at CHx". If yes, how does it work? Thanks for the help

Author:	HeliMLM [ Tue 05. Dec 2023 15:40:28 ]
Post subject:	Re: HOTT MX-16
from here (directly in first lines): https://manual.spirit-system.com/index. ... ntegration it should work - did you follow all the steps in this manual?

Author:

compuger [ Wed 06. Dec 2023 9:07:16 ]

Post subject:

Re: HOTT MX-16

Hello Michael, thanks for your quick tip. I have already discovered the instructions you mentioned and tried to follow them. Unfortunately I can't get any further. It seems that the “general module” is recognized as shown in the picture. But now I can't get any further. I also can’t find the “option SENSOR at Chx” setting. However, this setting probably only applies to the GR-12 receiver. I have GR-16 where SUMD is set to CH8. Maybe you have a tip from your experience with GR-16 and Sprit GT? Thanks in advance. Dieter

Attachments:

mx-16.jpg [ 41.62 KiB | Viewed 177 times ]

Author:	compuger [ Wed 06. Dec 2023 19:42:31 ]
Post subject:	Re: HOTT MX-16
Further attempts were unsuccessful. I can't do it. Apparently it only works with the latest generation of receivers. Sorry

Author:	ZeXx86 [ Wed 06. Dec 2023 20:05:00 ]
Post subject:	Re: HOTT MX-16
It will work for sure. You only have to select correct sensor in the radio. This is desribed in radio manual. I think it is pressing of some two buttons. Try pressing two Arrows as described in our guide.

Author:	compuger [ Thu 07. Dec 2023 16:34:06 ]
Post subject:	Re: HOTT MX-16
Hello, thanks again for the support. After further attempts I finally had success. The problem was connecting the cable to the Spirit GT module. The picture on the HOTT INTEGRATION page shows a different module. Unfortunately, there is no picture of the SPIRIT GT module with the correct pin assignment to be found anywhere. (Why?) It would have been very helpful for me and probably also for other users if a corresponding photo or image were available. But now it worked. Thanks again.

Page 1 of 1	All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/