I was able to fix the module using the pdf procedure now is at v3.1
next things to do is to remove the two resistors ... will do in the next days
thanks a lot Thomas
| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| [SOLVED] WiFi 3.1 https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=4015 |
Page 3 of 3 |
| Author: | ZeXx86 [ Mon 01. Jun 2020 18:26:00 ] |
| Post subject: | Re: WiFi 3.1 |
Fortune7 wrote: ZeXx86 wrote: Probably serial port you selected is not correct one or there is loose connection somewhere. Spirit unit is used only for powering. Power supply must be same for Wifi-Link and Spirit unit. OK, thanks, Tomas - I'll check again. Cheers, Andy If your module was not updated to 3.0.0 then this is not fix for you. |
|
| Author: | ajadda [ Mon 01. Jun 2020 18:46:34 ] |
| Post subject: | Re: WiFi 3.1 |
Hi, OK, I had success now repairing the WiFi-Link following the instructions. Must have been some connection-fault, after reconnecting it worked! Now I was able to flash version 3.1. I just need to reconfigure the WiFi-Link again. Thanks a lot, now I can flash the other one also. Regards, Alexander |
|
| Author: | ZeXx86 [ Mon 01. Jun 2020 19:22:56 ] |
| Post subject: | Re: WiFi 3.1 |
Fortune7: Do you think you are able to measure resistance of the resistors? Are you powering Wifi-Link and Spirit unit from the same power supply (BEC/battery)? |
|
| Author: | ZeXx86 [ Mon 01. Jun 2020 19:30:22 ] |
| Post subject: | Re: WiFi 3.1 |
ajadda: You are welcome! |
|
| Author: | Fortune7 [ Mon 01. Jun 2020 19:47:16 ] |
| Post subject: | Re: WiFi 3.1 |
ZeXx86 wrote: Fortune7: Do you think you are able to measure resistance of the resistors? Are you powering Wifi-Link and Spirit unit from the same power supply (BEC/battery)? OK, Tomas, my mistake was to power the Wifi adapter from a separate 2S battery. Now, with it connected to the BEC / Spirit supply, it works fine. So sorry to bother you with this dumb mistake - you are very busy and you don't need idiots taking up your time! Great Customer Service, as always! Many thanks, Andy |
|
| Author: | urgno [ Tue 02. Jun 2020 21:38:38 ] |
| Post subject: | Re: [SOLVED] WiFi 3.1 |
I was able to fix the module using the pdf procedure now is at v3.1 next things to do is to remove the two resistors ... will do in the next days thanks a lot Thomas |
|
| Author: | urgno [ Sat 06. Jun 2020 23:05:52 ] |
| Post subject: | Re: [SOLVED] WiFi 3.1 |
today i did the resistor removal and short and can confirm all works correctly on spirit2 too thanks Tomas |
|
| Page 3 of 3 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|