Spirit System
https://www.spirit-system.com/phpBB3/

Spm6210t & ix12 and spirit 2
https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=3998		 Page 1 of 1
Author:  Neilsteers [ Sat 23. May 2020 20:22:36 ]
Post subject:  Spm6210t & ix12 and spirit 2
Looking for help, have the 6210t connected to the spirit by JETI cable red and brown rudder and orange to pit, esc to aux1 , if I connect servos to rx they respond but connected to the spirit 2 they don’t and in both scenarios the bars do no move in the channel screen in the spirit wizard, what am I doing wrong ?
Author:  10x [ Sat 23. May 2020 22:21:57 ]
Post subject:  Re: Spm6210t & ix12 and spirit 2
I assume you mean the 6610t?. Have you set receiver type to SRXL2 in the Spirit in the general tab, then in rx....
Author:  Neilsteers [ Sun 24. May 2020 0:25:36 ]
Post subject:  Re: Spm6610t & ix12 and spirit 2
Hi
Yes the 6610t, and yes set to srxl2
Author:  HeliMLM [ Sun 24. May 2020 8:29:58 ]
Post subject:  Re: Spm6210t & ix12 and spirit 2
Neilsteers wrote:
.....and orange to pit...?


if you have really connected to PIT (middle pin) this is the problem... check wiring with Spirit manual: should be the topmost pin iirc.
Author:  Neilsteers [ Sun 24. May 2020 9:58:09 ]
Post subject:  Re: Spm6210t & ix12 and spirit 2
Hi Michael no the orange wire is in the top pin
Author:  HeliMLM [ Sun 24. May 2020 10:17:14 ]
Post subject:  Re: Spm6210t & ix12 and spirit 2
Ok... would have been an easy one :)

and the firmware on 6610T is updated and Spirit is using actual firmware?
Author:  latjo-k [ Sun 24. May 2020 10:31:36 ]
Post subject:  Re: Spm6210t & ix12 and spirit 2
HI follow this thread.
viewtopic.php?f=20&t=3791
Author:  Neilsteers [ Sun 24. May 2020 14:43:45 ]
Post subject:  Re: Spm6210t & ix12 and spirit 2
I have updated the rx but not the spirit software, software on wizard is showing latest release 2.8
Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/