|
It is currently Fri 26. Apr 2024 12:37:41
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 4 posts ] |
|
| Author |
Message |
|
Badger1666
|
 Posted: Mon 03. Feb 2020 22:25:54 |
|
Joined: Thu 14. May 2015 20:49:29
Posts: 11
|
|
After setting up spirit2 on a jumper t16
I have a issue, after powering up the rudder slowly goes full travel in one direction and stays there, I can move stick and rudder will move, but will always creep back to full travel on one direction.
What can cause this?
Thanks
|
|
| Top |
|
 |
|
Trek nut
|
Posted: Tue 04. Feb 2020 0:07:16 |
|
Joined: Sun 02. Apr 2017 17:49:47
Posts: 46
|
|
Hi ! Did you disable your rudder trim ?
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Tue 04. Feb 2020 13:51:16 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12234
|
|
Hi,
please check Diagnostic tab and verify that Rudder channel is at 0% when sticks are centered.
_________________
Spirit System developer
|
|
| Top |
|
|
|
Badger1666
|
Posted: Tue 04. Feb 2020 16:59:10 |
|
Joined: Thu 14. May 2015 20:49:29
Posts: 11
|
|
Hi
I bind the receiver again and all seems to work on the bench.
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 38 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
